This part describes the parameters of the tolerance bands.
|
Parameter |
Description |
|---|---|
|
In use |
This switch defines the use and the visibility of the tolerance band in JUMO smartWARE Program. |
|
Actual value |
This selection defines an actual value that is compared to its setpoint. |
|
Lower deviation min. value |
This value defines the smallest possible input value for the lower deviation value. Entering a permissible deviation of the actual value from 0 in JUMO smartWARE program, deactivates the tolerance band. To avoid this deactivation, the lower limit must be set > 0. |
|
Lower deviation max. value |
This value defines the largest possible input value for the lower deviation value. |
|
Upper deviation min. value |
This value defines the smallest possible input value for the upper deviation value. Entering a permissible deviation of the actual value from 0 in JUMO smartWARE program, deactivates the tolerance band. To avoid this deactivation, the lower limit must be set > 0. |
|
Upper deviation max. value |
This value defines the largest possible input value for the upper deviation value. |
|
Event type |
This selection defines the eventtype behavior in case of an deviation. Possible selections are:
|
|
Tolerance band behavior |
This selection defines the program behavior in case of an deviation. Possible selections are:
|
|
Lower deviation default value |
Initial setpoint when adding the process step to a program. |
|
Upper deviation default value |
Initial setpoint when adding the process step to a program. |
The tolerance bands must be configured in the JUMO smartWARE Setup variTRON. They can be found as follows:
Configuration > PT Configuration > Process steps > Process steps > 'Name' > Definition