Skip to main content
Skip table of contents

Digital PS setpoints

This part describes the parameters of the digital process step setpoints.

Parameter

Description

In use

This switch defines the output of the digital process step setpoint.
If the switch is active, the setpoint is output according to value and setpoint type.

Value

This value defines the output value of the digital process step setpoint.

Setpoint type

This selection defines a setpoint type. Possible selections are:

  • Direct

  • On delayed

  • Off delayed

  • On in advance

Function time

This value defines the advance time or delay time depending on the setpoint type.

On-time

This value defines the on-time for pulsating output.

The output will only pulsate if both On-Time and Off-Time have a value greater than zero.

Off-time

This value defines the off-time for pulsating output.

The output will only pulsate if both On-Time and Off-Time have a value greater than zero.

The digital process step setpoints must be configured in the JUMO smartWARE Setup variTRON. They can be found as follows:
Configuration > PT Configuration > Process step > 'Name' > Definition > Digital PS setpoints

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.